ITM01 quiz

Who is right?

• Technician A says that one function of a damage report is to help prevent misunderstandings between the repairer and customer.

• Technician B says that one function of a damage report is to document authorization to repair the vehicle.

• Both A and B

• Neither A nor B

Who is right?

• Technician A says that a heat gun may be used to remove emblems.

• Technician B says that a mixing board is used for mixing paint.

• Both A and B

• Neither A nor B

Answer explanation

Mixing boards are used to mix body filler.

Who is right?

• Technician A says that a Torx drive may be a type of screwdriver.

• Technician B says that a Phillips drive may be a type of screwdriver.

• Both A and B

• Neither A nor B

Answer explanation

Torx drives are designed to fit into a screw or bolt with the same star pattern.

the tool below is

• hammer
• dolly
• pick
• anvil

The tool in the photo is

• cold knife

• wire tool

• chisel

• trim removal tool

Answer explanation

This tool is designed to remove plastic clips

Who is right?

• Technician A says that a cold knife is pneumatic.

• Technician B says that a wire tool can be used for removing some trim.

• Both A and B

• Neither A nor B

Answer explanation

A cold knife is used to cut the windshield out of a car.

A wire can also be used to cut adhesives and remove some trim like moldings.

Who is right?

• Technician A says that an air chisel is used to dress welds.

• Technician B says that paintless dent repair (PDR) tools can be used to remove small dents.

• Both A and B

• Neither A nor B

Answer explanation

PDR uses glues or pics to remove small dents

Which of these is true about airbag charts?

• May be found in the vehicle owner’s manual

• Lists mandatory part replacement guidelines

• Includes procedures for airbag replacement

• Lists airbag part prices

Answer explanation

Airbag charts map out all sensors in the Supplemental Restraint System. In case of a crash, some of those sensors must be replaced for the airbags to work properly again after the accident.

What type of fastener is shown below?

• bolt

• screw

• clip

• pin

Answer explanation

Screws differ from bolts because a screw makes the threads or is driven into existing threads. Bolts are not taped and required a nut

What type of fastener is shown below?

• bolt

• screw

• clip

• rivet

Answer explanation

The long rivets are called pop rivets, and the smaller ones are called self-piercing rivets.