AutoCAD Quizziz - Daily Practice

To make lines go from a single lines to polyline, you simply select all the lines needed then type _ then press enter.

Open AutoCAD. Draw a polyline using the measurements below.

What is the area of the rectangle? XXX.XXX

Open AutoCAD. Draw a polyline using the measurements below.

What is the length of the rectangle? XX.XXX

Two types of arrays are:

• Polar

• Rectangle

• Linear

• Plan

Open the File, Daily Practice. Go to the "Round" View.

Create a Tan,Tan,Tan circle to look like the image below.

What is the Diameter of the circle?

XX.XXX

Open the File, Daily Practice. Go to the "Round" View.

Create a Center, Start, End arc using the geometric center of the rectangle. Follow the points.

What is the Area of the Arc?

XX.XXX

Go to the Shape View. Create a Fillet (F >Enter) to create the object below.

Radius =12.

What is the Area of the new object?

XXX.XX

Stretch the box shown up 3.5 units from the top midpoint. What is the length from the top midpoint to the bottom midpoint?

(Image should look like the red line)

XX.XX

Go to the Mirror View. Use the geometric center of the circle shown to create a mirror like the image shown.

What is the Length of Red Line shown?

XX.XXX

Open the File Daily Practice. Right Click, Quick Select. Object type=Polyline.

How many Polylines are in the entire drawing?