kocing

The shop head of a rivet should be?

• A. One and one-half times the diameter of the rivet shank
• B. One-half times the diameter of the rivet shank
• C. One and one-half times the diameter of the manufactured head of the rivet

One the main advantages of Hi-lock type fasteners over earlier generation is that?

• C. They can be installed with ordinary hand tools
• A. They can be removed and reused again
• B. The squeezed on collar installation provides a more secure, tighter fit

The marking on the head of a Dzus fastener identify the?

• A. Body diameter, type of head, and length of the fastener
• B. Body type, head diameter, and type of material
• C. Manufacturer and type of material

A well designed rivet joint will subject the rivets to

• B. Shear loads
• A. Compressive loads
• C. Tension loads

A main difference between lockbolt/huckbolt tention and shear fasteners (other than their applicationb) is in the

• A. Number of locking collar grooves
• B. Shape of the head
• C. Methode of installation

Alloy 2117 Rivets are heat threated

• A. By the manufacturer and don't require heat treatment before being driven
• B. By the manufacturer but require reheat treatment before being driven
• C. to a temperature of 91° to 93° F and quenched in cold water

Rivets used primarily for joining magnesium alloy structure have what alloy designation?

• D. 5056
• A. 1100
• B. 2017-T4
• C. 2117-T4

When space on side is too restricted properly use a bucking bar, what type of rivet should you use?

• C. Blind
• A. Flat
• B. Solid
• D. Hi-Shear

What distance will the stud of a Camloc fastener have to be turned to releade it but not far enough to permit re-engagement?

• D. One-fourth turn counterclockwise
• A. One-half turn clockwise
• B. One-fourth turn clockwise
• C. One-half turn counterclockwise

Where is an AN clevis bolt used in an airplane?

• C. Only for shear load application
• A. For tension and shear load condition
• B. Only for tension load application