LV13 IMI MOCK TEST

Which component is the synchromesh hub?

• A

• B

• H

• P

How would you check for clutch slip?

• Road test moving up and down the gear ratios without engaging the clutch.

• In 1st gear listen for noise as you release clutch.

• Handbrake on in 1st gear. Raise engine speed as you release the clutch.

• Handbrake on in 3rd gear. Raise engine speed as you release the clutch.

When measuring transmission electronic control component resistances you would use a:

• Multimeter set to VDC

• Multimeter set to amps

• Multimeter set to ohms

• Multimeter set to VAC

ATF fluid is discolored and smells burnt. One possible cause could be slipping clutches.

• True

• False

When checking current consumption of transmission electronic control components you would use:

• A tachometer

• An ammeter

• A heavy duty discharge tester

• A voltmeter

Which components is the speed drive gear?

• A

• M

• P

• O

A CVT belt has:

• A flat profile aluminium belt that transmits through friction.

• A vee profile rubber belt that transmits drive through torsion

• Extending steel belt that transmits the through compression.

• A vee profile steel belt that transmits drive through friction.

Whilst carrying out gearbox overhauls you should:

• Replace gearbox bearings.

• Replace all the gearbox gaskets.

• Tighten all bolts using a torque wrench.

• All answers shown.

When measuring transmission electronic control components voltages you would use:

• A multimeter set to VDC

• A multimeter set to amps

• A multimeter set to ohms

• A multimeter set to decibles

When checking the input and output values of a transmission electronic control components you would use:

• A hydrometer

• A heavy duty discharge tester

• A multimeter or oscilloscope

• A pressure gauge