Chapter 9

Which of the following describes a way to disable IEEE standard auto-negotiation on a 10/100 port?

• configure the speed 100 and duplex full interface subcommand.

• Configure the speed 10 and duplex half interface subcommand.

• Configure the speed 10 and duplex full interface subcommand.

• Configure the speed 100 and duplex half interface subcommand.

In which mode of the following modes of the CLI could you configure the duplex setting for interface Fast Ethernet 0/5?

• Interface Configuration Mode

• Global Configuration Mode

• Privileged EXEC Mode

• Subinterface Configuration Mode

In ​ (a)   communications, devices can send and receive signals, but not at the same time.

• half-duplex
• full-duplex
• duplex
• terminal

When configuring port security, what are two options that can be set to secure the port?

• mac-address

• maximum

• minimum

• all

When defining the violation for a secure port, which command will disable the port and send an SNMP message?

What are three speed settings for a port are ​ (a)   , (b)   , and ​ (c)   .

• 10Mbps
• 100Mbps
• auto
• 10Gbps
• 100Gpbs
• 1000Gbps

Which mode allows only one VLAN to pass?

• Access

• Trunk

• Hub

• Bridge

What are the two options available when configuring the mac-address for port security?

• sticky

• The MAC Address of the device

• shutdown

• reject

What is the default setting for speed and duplex on a port?

• autonegotiate

• Half Duplex

• Full Duplex

• 10 Mbps

Match the following options and their subcommands

• 100

• violation

• restrict

• duplex

• sticky

• port-security

• <cr>

• mac-address

• full

• speed