AMT 7A-05LC FINALS EXAM

1. What is the width of material measured around the bends from edge to edge?

• 1. Total Developed Width

• 1. Setback

• 1. Flat

What is the portion of a part that is not included in the bend?

• 1. Total Developed Width

• 1. Setback

• 1. Flat

What is equal to the base measurement (MLD) minus the setback?

• 1. Total Developed Width

• 1. Setback

• 1. Flat

What is the portion of a part that is not included in the bend?

• 1. Total Developed Width

• 1. Setback

• 1. Flat

What is less than the sum of mold line dimensions since the metal is bent on a radius and not to a square corner as mold line dimensions indicate?

• 1. Total Developed Width

• 1. Setback

• 1. Flat

6. Who designates specifications for the materials to be used to ensure the finished part has the correct temper when it leaves the machines, planning every part?

• 1. Factory Engineers

• 1. Factory draftsmen

• 1. Engineers

7. Who prepares a layout for each part?

• 1. Factory Engineers

• 1. Factory draftsmen

• 1. Engineers

8. What is achieved by hammering or rolling metal under pressure? 

• 1. Stretching

• 1. Shrinking

• 1. Bumping

10. Does hammering a flat piece of metal cause the material in the hammered area to become thinner in that area?

• 1. Stretching

• 1. Shrinking

• 1. Bumping

9. What if the material in the horizontal flange will merely bend down at the center, and the length of that flange will remain the same?

• 1. Stretching

• 1. Shrinking

• 1. Bumping