ALPHARD

Choose the incorrect description about features of hybrid system.

• Toyota Hybrid System-II (THS-II) is used.

• HV battery is located under the front seats.

• Service plug grip is located under the center console box.

• Auxiliary battery is located in the engine compartment.

Choose the incorrect description about features of transaxle and EPS. 

• For P810 hybrid transaxle, air-cooled type oil cooler is used to cool the MG1 and MG2.

• For A25A-FXS models, the electronic shift lever system is used to the shift control mechanism.

• If the parking lock needs to be released manually, remove the parking lock actuator and turn the parking lock shaft directly.

• Column assist type EPS is used.

Choose the incorrect description about main features of body electrical. 

• Touch tracer operation function displays the operation guide for the steering pad switches that the driver touches on the headup display.

• Camera cleaner system can be operated in 2 ways: pushing the wiper switch forward or operating the rear camera washer switch on the multi display.

• SEA system also activates when opening the back door in addition to the front doors.

• Interior lights and registers, etc., which were scattered on the roof, are integrated into the roof overhead console.

Choose the incorrect description about features of the engine.

• The engine used is an in-line 4-cylinder.

• The exhaust tail pipe has 2 drainage holes.

• The compression ratio is 14.0:1.

• None of the above

Choose the incorrect description about rear remote controller. 

• The rear remote controller is removable from charging stand in the rear No.1 seat armrest.

• The rear remote controller is connected to the radio receiver assembly via Wi-Fi.

• If the rear remote controller is taken out of the vehicle, sounds the buzzer and some functions are restricted.

• The rear remote controller cannot be operated without pairing with a radio receiver assembly.

Choose the incorrect description about blind spot monitor sensor and front side radar sensor.

• Beam axis adjustment is required when beam axis adjustment values can be transferred to new sensor by GTS.

• When replacing with a new sensor, the software must be written.

• Beam axis adjustment can be performed in 2 ways: adjustment using targets or driving adjustment.

• If the bumper cover is replaced or body repair is performed at the radio wave transmission area, “Driving Adjustment” cannot be performed.

The drainage hole is provided to the exhaust tail pipe for the reason of___________.

• This hole is provided to the tail pipe for discharging carbon deposits.

• This hole is provided to the tail pipe for discharging carbon deposits.

• This hole is provided for quietness and is not an anomaly.

• This hole is provided for Sports mode

In Electronic Shift Lever System procedure select the incorrect one.

• Fully apply the parking brake and chock a wheel to secure the vehicle.

• Remove some parts to access the shift control actuator.

• Grip the parking lock shaft and rotate it to release the parking lock.

• Make sure to wait for 1 minute after turning the ignition switch off.

The engine equipped with the New Alphard HEV  is the same engine being used to what models? 

• Corolla Altis HEV

• Yaris Cross HEV

• Rav 4 HEV

• Innova Zenix HEV

In lighting system, the ceiling color illumination system has _____ colors.

• 64

• 55

• 30

• 15