Test 1 - CCNA 1

Which functionality is provided by DHCP?

• automatic assignment of an IP address to each host

• remote switch management

• translation of IP addresses to domain names

• end-to-end connectivity test

Which memory location on a Cisco router or switch stores the startup configuration file?

• RAM

• ROM

• NVRAM

• Flash

3. When a hostname is configured through the Cisco CLI, which three naming conventions are part of the guidelines?

• • the hostname should be fewer than 64 characters in length

• • the hostname should be written in all lower case characters

• the hostname should contain no spaces

• • the hostname should end with a special character

• • the hostname should begin with a letter

A router with a valid operating system contains a configuration file stored in NVRAM. The configuration file has an enable secret password but no console password. When the router boots up, which mode will display?

• • global configuration mode

• • setup mode

• • Oprivileged EXEC mode

• • user EXEC mode

An administrator has just changed the IP address of an interface on an IOS device. What else must be done in order to apply those changes to the device?

• • Copy the running configuration to the startup configuration file.

• • Copy the information in the startup configuration file to the running configuration.

• • Reload the device and type yes when prompted to save the configuration.

• Nothing must be done.

Which memory location on a Cisco router or switch will lose all content when the device is restarted?

• ROM

• Flash

• NVRAM

• RAM

Why would a technician enter the command copy startup-config running-config?

• • to remove all configurations from the switch

• • to save an active configuration to NVRAM

• • to copy an existing configuration into RAM

• • to make a changed configuration the new startup configuration

Which two statements are true regarding the user EXEC mode?

• All router commands are available.

• Global configuration mode can be accessed by entering the enable command.

• The device prompt for this mode ends with the “>” symbol.

• Interfaces and routing protocols can be configured.

• Only some aspects of the router configuration can be viewed.

Which type of access is secured on a Cisco router or switch with the enable secret command?

• virtual terminal

• privileged EXEC

• AUX port

• console line

What is the default SVI on a Cisco switch?

• VLAN1

• VLAN99

• VLAN999

• VLAN100