NETESS 2.0 MODULE 13 QUIZ - Build a Home Network

True or False? A home router typically only provides wired access to the network. You have to buy a separate device for wireless access.

• true

• false

Answer explanation

1. The correct answer is false. Typically a home network uses an integrated router equipped with both wired and wireless capabilities.

Which of the following is used to connect a wired device to the internal switch of the home router?

• Ethernet port

• Internet port

• Wireless port

• Power port

Answer explanation

1. Ethernet ports connect to the internal switch portion of the router. These ports are usually labeled "Ethernet" or "LAN".

True or false? Certain areas of the electromagnetic spectrum can be used without a permit.

• true

• false

Answer explanation

1. The correct answer is true. Certain areas of the electromagnetic spectrum have been set aside to allow public use without the restriction of having to apply for special permits.

True or false? Wi-Fi, Bluetooth, and cordless phones all use the same frequency ranges.

• true

• false

Answer explanation

1. The correct answer is false. Wi-Fi uses two different frequency ranges: 2.4 GHz and 5 GHz. Bluetooth also uses the 2.4 GHz frequency range. However, cordless phones operate at a lower ~900 MHz frequency range.

Which wired network technology has an inner wire surrounded by a tubular insulating layer, that is then surrounded by a tubular conducting shield.

• Category 5 cable

• Coaxial cable

• Fiber-optic cable

Answer explanation

1. Coaxial cable has an inner wire surrounded by a tubular insulating layer, that is then surrounded by a tubular conducting shield.

Which organization is responsible for testing wireless LAN devices?

• IEEE

• Wi-Fi Alliance

• IETF

• TIA/EIA

Answer explanation

1. The Wi-Fi Alliance is responsible for testing wireless LAN devices from different manufacturers.

What is used to identify a specific wireless network?

• the Service Set Identifier (SSID)

• the network address

• the IP address of the router

• the network mode

Answer explanation

1. The SSID is used to identify a specific wireless network. It is essentially the name of the network.

True or False? If you have devices on your wireless network that are using a variety of different 802.11 standards, then you should set your network to the highest standard to get the best throughput.

• true

• false

Answer explanation

1. The correct answer is false. The network should be configured for mixed mode to include devices that use any of the existing Wi-Fi standards.

What is created when you divide up the available radio frequency spectrum?

• network

• SSID

• channel

• medium

Answer explanation

1. Channels are created by dividing up the available RF spectrum. Each channel is capable of carrying a different conversation

What is the method used to create a reservation on the channel for a specific conversation between devices?

• CSMA/CA

• CTS

• SSID

• ACK

Answer explanation

1. Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) is the method used on wireless networks to create a reservation on the channel for a specific conversation between devices.