Recap Test Electrics L3

What are the terminals on a standard NPN Transistor?

• Neutral Live Earth

• Collector, Base, Emitter

• Live, Ground, Signal

• Positive Negative Positive

What is an acceptable amount of volt drop in the live side of an operational circuit?

• 12V

• 12.6V

• 0.5V

• 2V

Using a test lamp in an electrical circuit runs the risk of...

• Drawing a higher current than a multimeter.

• Drawing a lower current than a multimeter.

• Increasing Voltage Output

• Blowing the lamp

Which Network did most of the smart charge alternators utilise for communication?

• MOST

• CAN

• LAN

• LIN

AGM in regards to batteries stands for...

• Annual General Material

• Absorbent Gel Material

• Absorbent Glass Mat

• Annual Glass Mat

Where can MOSFETs commonly be found?

• Mounted next to the battery.

• Inside of control modules

• Starter motor

What should the voltage drop be across a switch in the closed position?

• 0V ideally, MAX 0.5V

• 12V Ideally, MAX 12.6V

• 2-5V

• 3V

Which Relay Pins form the Control Circuit on a DIN standard Relay?

• 87 and 86

• 30 and 85

• 30 and 87

• 85 and 86

What tool should be used to test for a parasitic drain

• Dwellmeter

• Voltmeter

• Ammeter/Amp Clamp

• Ohmetter

How should voltage in a circuit be measured?

• Series and parallel

• Series

• Parallel

• Circuit Disconnected