Dremel 3D Units 4 and 5

What is the name of Dremel's cloud-based slicing software and operating system mentioned in the video?

• Simplify3D

• Cura

• 3D Printer OS

• Tinkercad

What are the buttons mentioned in the 3D Printer OS software?

• Repair, Slice, Print, Upload

• Rotate, Scale, Print, Repair

• Upload, Edit, Print, Scale

• Repair, Layout, Slice, Print

What is the purpose of the 'Repair' button in the 3D Printer OS software?

• To repair and rotate the file

• To upload a file

• To select the type of support

• To change the layer height

What can be adjusted in the 'Layout' step of the 3D Printer OS software?

• Support type

• Rotation and scaling

• Infill density

• Layer height

What does the 'Slice' step in the 3D Printer OS software allow you to do?

• View the project

• Check the temperature

• Select the layer height

• Choose the support type

What does the infill density setting in the slicing software refer to?

• The speed of the print

• The type of support used

• The percentage of fill on the inside of the print

• The thickness of each layer

What can cause the issue of 'spaghetti' in a 3D print?

• • Model was saved with minimal surface area contacting the build plate

• • Object was built floating above the build platform with no support selected.

• Clogged extruder

• Filament running out

What should be done if the extruder gets clogged?

• Change the filament

• Level the build plate

• Adjust the print settings

• Stop the job and purge out the old filament

What are two possible solutions if the layers of a print are not sticking properly?

• Increase the infill density

• Use a different filament

• Level the build plate

• Make sure there is glue on the build plate

What is an important factor to do before each time you build?

• Level the build plate

• Never use support

• Adjust the layer height

• Change the safety settings