Ase b5 Review

A driver's side airbag was cut during a collision but did not deploy. What is the proper action?

• use plastic repair adhesive to repair the cut and refinish the bag

• return the bag to the manufacturer for recycling

• replace the bag with an OEM part, deploy the old bag before disposal

• replace with a salvage part

A repaired vehicle is found to have an SAI difference where one side is within specs and the other side is out. Technician A says to bend the strut on the out of spec side to get it to align. Technician B says that cradle might have shifted. Who is right?

• tech A

• Tech B

• Both

• Neither

The fuel filter may be located in all of the following locations EXCEPT:

• in the tank

• just outside the tank

• on the fuel rail

• inside the engine compartment

Technician A says the incorrect rear wheel camber and toe settings may cause bump steer. Technician B says they may cause a tracking problem . Who is right?

• Tech a

• Tech B

• both

• neither

Air intake systems perform all of the following functions EXCEPT:

• filter air for the interior of the vehicle

• control noise from the intake system

• filter air to the engine

• smooth the air flow into the intake system

Technician A says that a bump steer condition is caused by an out-of-level center link or rack-and-pinion. Technician B says that bump steer is most noticeable when the front wheels hit a bump. Who is right?

• Tech A

• Tech

• Both

• Neither

The right disc brake caliper and pads must be replaced during collision repairs. What other actions must take place?

• Bleed Brakes

• Top Off Coolant

• Check Oil

• Install New Rotor

One headlight on a vehicle won't light. Technician A says to begin by checking for voltage to the headlight switch. Technician B says to begin checking on the headlight side of the circuit. Who is right?

• Tech A

• Tech B

• Both

• Neither

Which is the proper brake fluid to use on most vehicles?

• DOT 5

• DOT 3 or 4

• ABC 3 or ABC 4

• DOT 2

A vehicle has a blown fusible link. Technician A says to replace it with the same size in-line fuse. Technician B says to replace it with a fusible link two gauges heavier to keep it from blowing again. Who is right?

• Tech A

• Tech B

• Both

• Neither