Vehicle prep, careers, cleaners

Which is the correct lubricant for the front axle on a rear-wheel-drive car?

• A motor oil

• B. transmission fluid

• c. white lithium grease

• D. wheel bearing grease

Technician A says it is acceptable to use brake cleaner to clean throttle bodies. Technician B says it is acceptable to mix DOT 5 brake fluid with DOT 3 brake fluid. Who is right?

• A only

• B. B only

• C. Both A and B

• D. Neither A nor B

Where should cleaning chemicals be stored in the auto shop?

• A file cabinet

• B. fire-retardant cabinet

• C. instructor's office

• D. side tray

Where on a vehicle should a VIN be found?

• A driver's door frame

• B. engine block

• C. operator's manual

• D. service manual

What are the three C's associated with a work order?

• concern, cause, coordinate

• B. concern, cause, correction

• C. cause, correction, cost

• D. cause, cost, coordinate

Which tool should be used to remove an oil filter?

• A oil filter clamp

• B. oil filter press

• C. oil filter screwdriver

• D. oil filter wrench

What is the most common type of hammer used in an automotive shop?

• ball peen

• dead blow

• c. impact

• D. sledge

What should be done to air tools daily to keep them in good working condition?

• A Disassemble them.

• B. Oil them.

• C. Wash them.

• D. Grease them.

Which tool would be used along with a hammer to cut a rounded-off nut on a vehicle?

• A chisel

• B. file

• c. punch

• D. screwdriver

Which tool would most likely be used to remove a brake line?

• A box-end wrench

• B. open-end wrench

• C. pipe wrench

• D. tubing wrench