DSL 203 I-Shift W02 Test

At what speed does Hill Start Assist activate?

• 0 MPH

  
  

• 2 MPH

• 12 MPH

• None of the Above

What is the minimum grade elevation requirement for the Hill Start Assist feature to
activate?

• 12 percent

• 2 percent

  
  

• There is no minimum

• There is no minimum

How is the Kick-Down feature activated?

• Press accelerator completely

• Hold Accelerator at 100% for 10 seconds

• It is optimized for grade

• None of the Above

How is the dynamometer mode activated?

• Place the gear selector in the drive position

• Hold accelerator at 100% for 10 seconds

• Both of these

  
  

• None of these

Technician A states the I-shift transmission is operated pneumatically and supplied by the secondary tank.
Technician B states in the event of air system failure the I-shift transmission air tank has a check valve to protect it's air supply. Who is correct

• Technician A only

• Technician B only

• Both Technician A and Technician B is correct

• Neither Technician A nor Technician B is correct

What does the X1 value represent?

• Current clutch position

• Number time the clutch was engaged

  
  

• Starting point of new clutch

• The wear factor of the clutch

What happens when the X2 value reaches the calculated clutch replacement
specification?

• A fault code is stored in the ecm

• A fault code is stored in the vcu

• A fault code is stored in the ABS module

• A fault code is stored in the TCM

  
  

The TCM is mounted to the Control Housing.

• True

• False

There are no physical differences between a direct and overdrive TCM,
software determines solenoid responsibility.

• True

• False

How many speed sensors are mounted internally on the I-shift?Required to answer. Single choice.

• 1

• 3

• 2

• 7