11 DRILLING TIPS AND TRICKS (And Mistakes To Avoid!) YouTube

What is the purpose of pre-drilling before driving a fastener?

• To remove wood and give the screw room to enter the material

• To prevent the drill bit from breaking

• To make the drilling process faster

• To create a rough surface for the screw to grip

• To prevent wood from splitting

What is the purpose of using a punch before drilling a hole?

• To prevent the drill bit from spinning

• To create a precise place for the drill bit to start without wandering

• To make the drilling process louder

• To make the hole larger than necessary

Why should drill bits not be forced when drilling? (pick 2)

• Because they are not sharp enough to cut through the material

• Because if it is a small bit you could break it

• Because they are not designed for drilling

• Because they are designed to cut through the material with constant pressure

What is swarf and why is it important to clear it out while drilling?

• A type of wood, and it can make the drilling process smoother

• A type of fastener, and it can prevent the wood from splitting

• Waste wood produced while drilling, and it can prevent the drill bit from cutting effectively

• A type of drill bit, and it can improve the drilling process

Why is it recommended to step up drill bit sizes when drilling a hole?

• To make drilling each pass easier and prevent wood grain tear out

• To save time and effort during the drilling process

• To prevent the drill bit from breaking

• To make the hole larger than necessary

How can tape be used to prevent splintering while drilling?

• By preventing the drill bit from spinning

• By making the hole larger than necessary

• By stabilizing the wood grain beneath and preventing the drill bit from causing damage

• By making the drilling process faster

Why is it important to use high speeds when drilling wood?

• To make the drilling process quieter

• To prevent the wood from splitting

• To break off wooden micro bits more easily and achieve a cleaner hole

• To prevent the drill bit from cutting effectively

What is the recommended approach for drilling metal?

• Using a hammer to drive the drill bit into the metal

• Using a larger drill bit to remove more material at once

• Using high speeds and constant force to quickly drill through the metal

• Using slow speeds and pressure to allow the bit to slowly dig in and begin gouging out material

How can the 'eyeball method' help in determining the right drill bit size for a fastener?

• By measuring the diameter of the screw and using a chart to determine the drill bit size

• By using a ruler to measure the diameter of the screw and finding a drill bit of the same size

• By comparing the size of the drill bit to the shaft and threads of the screw to find the appropriate size

• By using a random drill bit size and testing it with the screw to see if it fits

What is the 'hogging out' technique used for in drilling?

• To create precise holes without any tear out in the wood

• To make the drilling process quieter

• To remove more material by aggressive reaming, especially when a fastener doesn't fit into a pre-drilled hole

• To prevent the drill bit from breaking while drilling