IMI LV12 - Revision

In a 2:1 gear ratio - If Input torque is 120nm @ 5000rpm - Output torque =

• 240Nm at 2,500rpm

• 140Nm at 1,250rpm

• 240Nm at 3,500rpm

• 140 Nm at 2,500rpm

what is the purpose of the interlock mechanism?

• prevent two gears being selected at the same time

• lock the gear in place once it has been selected

• prevent the gears from crashing during gear changing

what do you lubricate CV joints with?

• grease

• silicone lube

• WD40

what noise does a faulty wheel bearing make?

• a knocking noise

• a humming noise

• no noise

lack of free play, oil contamination on flywheel would cause which fault?

• Clutch slipping

• Low clutch fluid

what would cause the clutch to slip?

• Too much clutch free play

• Very dry clutch plate

• Worn clutch pedal bushes

• Not enough clutch free play

when changing gear the transmission does not deselect 2nd gear, what could result?

• the driver to select reverse when driving

• the driver to select reverse when driving

• the transmission to completely lock up

• the gear lever to fall out

what turns drive through 90degree or what allows 1 wheel too turn faster than the other

• a differential

• a free wheel mechanism

The coefficient of friction of the clutch disc?

• decreases with friction plate wear

• remains constant with friction plate wear

• is adjustable for friction plate wear

• increases with friction plate wear

The coefficient of friction of the clutch disc?

• decreases with friction plate wear

• remains constant with friction plate wear

• is adjustable for friction plate wear

• increases with friction plate wear