217 PP2 sanitation Plastic Guttering System Quiz

Which part is used to stop the flow at the end of a gutter?

• Gutter joint

• Stop end

• RWP clip

• Drain connector

What is the standard size for downpipe systems?

• 50mm

• 68mm

• 75mm

• 62mm

What shape are downpipes typically?

• Square

• Rectangular

• Round or square

• Triangular

What is the angle of a gutter angle fitting that is greater than the standard angle for a 112mm plastic gutter system?

• 45°

• 90°

• 135°

• 180°

Which fitting is used to join two sections of a 112mm plastic gutter system?

• Gutter union

• Running outlet

• External stop end

• 135° gutter angle

What is the purpose of an offset bend in guttering?

• To connect two pipes of different diameters

• To change the direction of the downpipe or create a 'swan neck'

• To seal the end of a downpipe

• To increase the flow rate of water through the downpipe

How many offsets are required to create a 'swan neck'?

• One

• Two

• Three

• Four

What is the purpose of the guttering component shown in the image?

• To measure the flow of water in rainwater pipes.

• To join two rainwater pipes.

• To stop the flow of water in rainwater pipes.

• To filter debris from rainwater pipes.

What is the function of a gutter union in guttering components?

• It is used to seal the end of the gutter.

• It acts as a support for the gutter run and as a connector where two lengths of gutter join.

• It is used to change the direction of the gutter.

• It collects debris to prevent clogging in the gutter system.

What is the function of an external stop end in guttering components?

• It allows rainwater to flow out of the gutter.

• It connects to the end of a gutter run and stops rainwater pouring out of the end.

• It filters debris from the rainwater in the gutter.

• It seals the gutter from the inside.