9189PH2CWPPT3Q1

When installing cold water pipework, what should be taken into account to prevent problems related to frost and heat?

• Pipework should be positioned near heat sources.

• Pipework should be buried in walls or floors without access.

• Pipework should be avoided in positions where frost and heat could cause a problem.

• Pipework should be openly displayed in living areas.

Where should pipework ideally be positioned in a property?

• In plain sight within main living spaces.

• Out of eyesight and boxed in where appropriate.

• Only in outside walls and unheated roof spaces.

• In frequently used pathways for easy access.

Before installing cold water pipework, why is it important to "walk the job"?

• To find the nearest coffee shop

• To estimate the cost of pipework

• To plan the routes that the pipework will take

• To meet the customer's neighbors

What should be done to ensure that existing system controls are accounted for before installing new pipework?

• Turn off all the valves

• Paint the valves

• Locate relevant valves

• Replace all valves

What is a necessary step to take when preparing for pipework installation that involves the floor?

• Polishing the floorboards

• Lifting floorboards temporarily

• Permanently removing floorboards

• Ignoring the floorboards

Why is "marking out" an important step in the preparation for installing pipework?

• To decorate the installation area

• To indicate where to paint

• To mark the locations of electrical outlets

• To indicate pipework routes

What should be done to protect the customer's property during the installation of pipework?

• Sell the property

• Cover or move the customer's property

• Leave the property as it is

• Insure the property

According to the Water Regulations guide, where should water fittings not be located?

• Above a suspended ceiling

• Located in the cavity of a cavity wall

• Embedded in a wall that can be easily exposed

• Installed below a suspended or solid floor at ground level

Water pipes laid in walls should be accessible. Which of the following is not a recommended practice for pipe installation as per the Water Regulations guide?

• Installing pipes in a chase or duct that can be readily exposed

• Placing pipes under a suspended floor that can be easily removed if necessary

• Embedding pipes in any wall or solid floor

• Ensuring there is access to pipes for potential replacement

What should you always check for before drilling into walls and surfaces for installation?

• Electrical outlets

• Buried pipes or cables

• Paint quality

• Wall thickness