What is station number?

The station number is the distance in centimeters of a cross-section from a reference point.

The station number is the distance in centimeters of a cross-section from the Forward bulkhead.

The station number is the distance in inch of a cross-section from a reference point.

The reference (station 0) for all structural measurements for the X axis is set at:

100 in (254 cm) forward of the A/C nose,

200 in (508 cm) forward of the A/C nose,

100 in (254 cm) after of the A/C nose,

Access doors and panels are identified by:

The number of the zone in which the panel is located followed by a two-letter suffix.

The number of the zone in which the panel is located followed by one letter suffix.

a two-letter followed by the number of the zone in which the panel is located suffix.

In the AMM tasks, “WARNING” is meant:

Calls attention to use of materials, processes, methods, procedures or limits which must be followed precisely to avoid injury of death to persons

Calls attention to methods and procedures which be followed to avoid damage to equipment

Calls attention to methods which make the job easier or provide supplementary or explanatory information

The aircraft frame 24 station is 950, it means:

The frame 24 distance to the reference point is 950 cm

The frame 24 distance to the reference point is 950 inch

The frame 24 distance to the aircraft nose is 950 cm

Application of flight configuration precaution is required when

Jacking a MLG for wheels change

Lifting the aircraft at Forward Jacking Point, MLG Wheels on the Ground

You can weigh the aircraft with

The aircraft on jacks or the aircraft on its wheels or the aircraft on landing gear jacks

The aircraft on its wheels only

When the NLG dimension H is more than 300 mm

Do not tow the aircraft to prevent damage to the centering cams

Do not tow the aircraft to prevent tail to ground contact

Smooth and speed limited towing is possible

Safety requirements for aircraft refueling and defueling are

Do not operate the weather radar or HF system

Operate the cell phones or mobile phones inside distances for 6m from aircraft is allowed

Perform the operation test of the beacon or strobe light system

When you do the refueling and/or defueling in the hangar

The hangar doors must not be closed until you have completed the refuel/defuel procedure

The hangar doors must be closed until you have completed the refuel/defuel procedure

There is no requirement for hangar door

Longitudinal direction of the fuselage,

When you set the BAT 1&2 P/BSW to AUTO position:

The right hand dome light is on,

The left hand dome light is on,

When you perform the overhead panel checklist and a/c power supply. The voltage should be about 25 volts with:

The BAT 1&2 P/BSWs in OFF position.

The BAT 1&2 P/BSWs in ON position,

The BAT 1&2 P/BSWs in AUTO position,

Each area is identified by:

The major zones, the sub-zones, the zones.

ST9500/FR24 is located:

9500 mm from the reference point

9500 cm from the reference point

How does the flight crew manually fly the aircraft?

by side sticks mounted on the side consoles

by side sticks mounted on the center pedestal

Where safety instructions can be found?

in AMM(Aircraft maintenance Manual)

in SRM(Structure Repair Manual)

in ASM(Aircraft schematic manual)

What is Safety precautions must be taken to avoid danger from engine suction and exhaust areas?

Access to the engine is only allowed through the entry corridor. Entry corridor must be closed for wind direction greater than 90o. There is no safe access corridor when the engine is running above minimum idle.

Access to the engine is allowed entry in front of engine when engine is runing above minimum idle.

Access to the engine is allowed entry behide of engine when engine is runing above minimum idle.

Which jacking point use to lift the aircraft?

Nose l/g jacking point and main landing gears jacking point

Nose l/g jacking point and main landing gears jacking point and safety stay

Towing can be carried out using:

Towbar or towbarless tractor at NLG

Towbar or towbarless tractor at MLG

A 320/321 are the aircrafts with:

flight–by–wire flight controls

For the horizontal stabilizer the reference station 0 is at the horizontal Y axis and at:

the middle horizontal stabilizer

If an ENGINE is running

Either tow or push is possible.

You can tow the aircraft from the front only.

You can push the aircraft only.

There is no safe access to the engine through the entry corridor when: (level 1)

Engine is running above minimum idle

Engine is running up to minimum idle

Engine is running at any power setting

ATA 00 CL B A321 Quiz: 52 Practice Questions

52 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

The A318, A319, A320 and A321 (A320 family) are:

Single Aisle, twin-engine subsonic medium range aircraft.

Single Aisle, twin-engine subsonic short range aircraft.

Double Aisle, four-engine subsonic long range aircraft.

2.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Amber colour is used:

For failure needing awareness but no need immediate action,

For failure needing awareness and immediate action,

To indicate normal operation of system.

3.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

How many main zone of the aircraft:

Six.

Seven.

Eight.

4.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Zone number 100 -199 are located:

Lower half fuselage.

Upper half fuselage.

Landing gear.

5.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Station 0 is located:

200 inch from nose of aircraft,

150 inch from nose of aircraft,

100 inch from nose of aircraft.

6.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

What you must NOT do:

lift the aircraft at the forward jacking point only, with the wheels of the main landing gear on the ground

use the safety stay as soon as the lift operation is finished

use the safety stay to lift the aircraft

7.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

What is the correct sequence?

install the tow lever safety pin then install the tow bar on the tow fitting

install the tow bar on the tow fitting then install the tow lever safety pin

there is no specific sequence

Access all questions and much more by creating a free account

Create resources

Host any resource

Get auto-graded reports

Continue with Google

Continue with Email

Continue with Microsoft

or continue with

Facebook

Apple

Others

By signing up, you agree to our Terms of Service & Privacy Policy

Already have an account?

Similar Resources on Wayground

50 questions

End of Semester Assessment

Quiz

•

Professional Development

48 questions

English - Book 11 Unit 2

Quiz

•

Professional Development

50 questions

EE 1-1

Quiz

•

Professional Development

51 questions

haveyouseenthisgirl

Quiz

•

Professional Development

50 questions

EE 2-1

Quiz

•

Professional Development

50 questions

ESAS 9-1

Quiz

•

Professional Development

50 questions

ESAS 9-2

Quiz

•

Professional Development

Popular Resources on Wayground

21 questions

Continents and Oceans

Quiz

•

6th Grade

20 questions

Parts of Speech

Quiz

•

5th Grade

16 questions

Subject & Predicate

Quiz

•

5th Grade

25 questions

Multiplication Facts

Quiz

•

5th Grade

12 questions

Map Skills

Quiz

•

3rd Grade

22 questions

Continents and Oceans

Quiz

•

5th Grade

15 questions

Rounding Decimals

Quiz

•

5th Grade

20 questions

Brand Labels

Quiz

•

5th - 12th Grade

Discover more resources for Mathematics

10 questions

How to Email your Teacher

Quiz

•

Professional Development

40 questions

Flags of the World

Quiz

•

KG - Professional Dev...

4 questions

Exit ticket for the end of class: Spotlight

Quiz

•

KG - Professional Dev...

20 questions

90s Cartoons

Quiz

•

Professional Development

20 questions

Block Buster Movies

Quiz

•

10th Grade - Professi...

10 questions

How to Email your Teacher

Quiz

•

Professional Development

ATA 00 CL B A321

The A318, A319, A320 and A321 (A320 family) are:

Amber colour is used:

How many main zone of the aircraft:

Zone number 100 -199 are located:

Station 0 is located:

What you must NOT do:

What is the correct sequence?

Where is access panel 540 BB located?

Sub-zone for LH side of Horizontal Stabilizer is identified by:

What is station number?

Access all questions and much more by creating a free account

Similar Resources on Wayground

Popular Resources on Wayground

Discover more resources for Mathematics