What should they do? (select Two)

• Enable legacy BIOS compatibility mode.

• Disable Secure Boot.

• Enable TPM.

• Configure a user password.

• Configure Startup Settings.

what type of device connects to this connector?

• Hard Disk

• Display Monitor

• Any Serial Device

• Multifunction Printer

What should they do to enable the device?

• Install the device driver from the manufacturer website.

• Perform a low-level format of the device.

• Create at least one primary partition on the device.

• Use the plug and play device driver.

Which solution eliminates a single point of failure?

• Plug the server into a surge protector.

• Plug the server into a UPS.

• Install a modular power supply.

• Install a redundant power supply.

Which hard drive option should they choose?

• 1 TB 7200 rpm HDD

• 3 TB SSD

• 1 TB SSD

• 1 TB 5400 rpm HDD

What should they use?

• Blu-ray Disk Drive

• SDHC card

• HDD drive

• SSD drive

Which RAID level does the new hardware need to support?

• RAID 10

• RAID 5

• RAID 0

• RAID 1

What should the technician do to test the repair?

• Replace the resin.

• Calibrate the ribbon.

• Load the filament.

• Activate the fuser.

What should be done?

• Configure the disk as a dynamic disk.

• Set the BIOS system password.

• Set the BIOS HDD password.

• Disable the HDD through the BIOS.

What should they do next?

• Wait at least five minutes, restore power, and restart.

• Restore power to the computer, insert a bootable CD, and restart the computer.

• Remove the CMOS battery from the motherboard for a few minutes, and then replace the battery, restore power, and restart.

• Disconnect the motherboard power cables, wait a few minutes and then reconnect the cables, restore power, and restart.