Lesson 107 – Conduit Bending

What is the objective 107.1 for Lesson 107 – Conduit Bending?

• Outline the safety procedures for conduit bending.

• Label the points on a hand bender and list terms used in conduit bending.

• Describe the types of conduit materials and their uses.

• Explain the electrical theory behind conduit bending.

What is the objective 107.2 for Lesson 107 – Conduit Bending?

• Demonstrate the practical application of bending conduit.

• Identify the tools required for conduit bending.

• Outline mathematical calculations and apply them to bending conduit.

• Compare different methods of conduit installation.

What is a dog leg in conduit bending?

• A tool used for bending conduits

• A bending mistake where two bends in a raceway are not in the same plane

• A type of conduit connector

• A measurement technique for conduit installation

What does a kick refer to in conduit bending?

• A bending mistake similar to a dog leg

• A specialized bending machine

• A single bend in a raceway that changes the direction of the run

• A method to secure conduits in place

What are concentric bends?

• Bends that are made at the same angle

• Bends that are made in conduits that are installed side-by-side and need to be turned around a corner

• Bends that are made with different radius points

• Bends that are made without any tools

Which part of the conduit has the shortest radius length when using a hand bender?

• The part closest to the radius point

• The part farthest from the radius point

• The part at the center of the conduit

• The part where the conduit is straight

Where should foot pressure be applied when using a hand bender?

• On the hook

• On the star

• On the arrow

• On the designated foot pressure area

What is the purpose of the 'line of sight' on a hand bender?

• To indicate where to cut the conduit

• To provide a reference for the bend angle

• To show where to apply foot pressure

• To mark the radius point

What is indicated by the 'star' on a hand bender?

• The starting point for the bend

• The point where foot pressure should be applied

• The end point of the bend

• The location of the hook

When bending 1/2" EMT, what position should the handle of the bender be in?

• Handle up

• Handle down

• No specific position

• At a 45-degree angle