27202 #8 Apply roof Framing

Which of the following is NOT a topic covered under the objectives of Session Eight?

• Roof projections

• Flashing

• Ventilation

• Gutter installation

What is the performance task for Session Eight in the roofing applications module?

• Demonstrate the use of metal roofing tools

• Properly cut and install the ridge cap using composition shingles

• Design a new type of roofing material

• Inspect and repair damaged roof tiles

What additional component is mentioned to be installed in the performance task besides the ridge cap?

• A solar panel

• A chimney

• A cricket or saddle

• A skylight

What is the first step in installing vent-stack flashing according to the diagram?

• Apply sealant around the base of the stack

• Apply roofing up to where stack projects and cut and fit shingles around stack

• Install the underlayment over the stack

• Secure the stack with nails

What is the next step in installing vent-stack flashing after placing the flange over the stack according to the image provided?

• Secure with nails

• Apply a sealant around the edges

• Press down into roofing cement

• Cover with additional underlayment

What is the purpose of molding the flange to the vent-stack in roofing applications?

• To increase the aesthetic appeal of the roof

• To ensure a snug fit

• To make the installation process faster

• To reduce the cost of materials

What should be applied to the top of the flange during the installation of a soil stack?

• Paint

• Oil

• Cement

• Water

What is the final step in installing vent-stack flashing as described in the image?

• Apply a sealant around the base

• Install the remainder of shingles

• Attach the vent-stack cap

• Conduct a waterproofing test

What is the purpose of using metal step-flashing shingles in vertical wall flashing?

• To enhance the aesthetic appeal of the roof

• To provide structural support to the roof

• To ensure waterproofing at the junction of the roof and vertical walls

• To increase the thermal insulation of the building

Where should metal step-flashing shingles be applied in vertical wall flashing?

• Over the top of each course of shingles and under the next course

• Directly on the roof deck without covering

• Only on the sidewalls

• At the edges of the roof only