Calibration

The Calibrators are assigned to perform calibration as requested by DPWH, Sorsogon 1st DEO, located at Guinlajon, Sorsogon City.

What type of Calibration Form will be used?

• Abrasion Spheres Form

• Laboratory Oven Form

• UTM, Compression/Flexural Testing Machine Form

• Laboratory Scales/Balances Form

In the previous question, what is the Name of the Client that will be calibrated?

• DPWH, Region V

• DPWH, Sorsogon 1st DEO

• DPWH, BRS

• DPWH, Sorsogon 2nd DEO

In filling out the calibration form, which of the following should be indicated in the Office Address of the Client?

• Guinlajon, Sorsogon City

• Rawis, Legazpi City

• DPWH, BRS

• DPWH, Sorsogon 2nd DEO

What type of Equipment will be calibrated?

• UTM

• California Bearing Ratio Machine

• Pipe Tester

• Compression Machine

What is the Brand of the Calibrated Equipment?

• Controls

• Matest

• Civit Test

• Italy

When is the Date of Calibration of the Equipment?

• May 27, 2024

• May 22, 2024

• May 21, 2024

• May 21, 2025

The Calibration of Equipment is Valid until:

• May 27, 2024

• May 22, 2025

• May 21, 2024

• May 21, 2025

What is the Capacity of the Compression Machine?

• 323.65 cm2

• 190 mm

• 2000 / 250 kN

• 618.17/77.27 bar

What is the Serial Number of the Compression Machine?

• YIM2000KNFMT/AI/0099

• YIM2000KNFMT

• 24048

• En. 1622 J

For UTM, Compression/Flexural Testing Machine, it has a maximum allowable error of ± 1% as per ASTM E74 and ASTM E4.

With the given data and results, as a calibrator, what will be your remarks/recommendation?

• The equipment is not ready to use for testing

• The equipment is subject for repair

• The equipment is subject for recalibration

• The equipment is ready to use for testing