Chapter 2’s Most Difficult Questions

The lateral dimensions of Class D airspace are based on

• The number of airports that lie within the Class D airspace

• 5 statue miles from the geographical center of the primary airport

• The instrument procedures for which the controlled airspace is established

(Refer to figure 75, area 6) During preflight planning, you plan to operate in R2305. Where would you find additional information regarding this airspace?

• In the Special Use Airspace area of the chart

• In the Aeronautical Information Manual

• In the Chart Supplement U.S.

(Refer to figure 78) You have been hired to fly your UA to inspect train tracks from the town of Hinton to the town of Winnebago. Will you be able to conduct this flight without contacting ATC?

• Yes, because you will remain under 400 ft

• No, because you will pass through Echo airspace

• No, because you will pass through Delta airspace

(Refer to figure 26, area 4) You have been hired to inspect the tower under construction at 46.9N and 98.6W, near Jamestown Regional (JMS). What must you receive prior to flying your unmanned aircraft in this area?

• Authorization from the military

• Authorization from ATC

• Authorization from the National Park Service

(Refer to figure 69) What does the line of longitude at area 7 measure?

• The degrees of longitude north and south of the prime meridian

• The degrees of longitude north and south of the equator

• The degrees of longitude east and west of the line that passes through Greenwich, England

(Refer to figure 20, area 3) What is the latitude and longitude location of the Elizabeth City CGAS RGL (ECG)?

• N 36 degrees 16’ W 76 degrees 10’

• W 36 degrees 16’ N 76 degrees 10’

• N 37 degrees 0’ W 77 degrees 10’

Which technique should a remote pilot use to scan for traffic?

• Continuously scan the sky from right to left

• Concentrate on the relative movement detected in the peripheral vision area

• Systematically focus on different segments of the sky for short intervals

(Refer to figure 76) What ATC permissions are required to operate near Anderson Airport?

• ATC clearance required

• No ATC permission is required

• Waiver must be requested

(Refer to Figure 78, near the center of the chart) What class of airspace is associated with SIOUX GATEWAY/COL DAY (SUX) Airport?

• Class B airspace

• Class C airspace

• Class D airspace

(Refer to figure 31) Within what airspace is Coeur D’Alene Pappy Boyington Fld located?

• Class B

• Class E

• Class D