EE030 Grp 1 SW

Receptacle outlets shall be calculated at not less than ______ volt-amperes for each single or for each multiple receptacle on one yoke.

• 230

• 120

• 180

• 90

For dwelling units, the calculated floor area shall include open porches, garages, or unused or unfinished spaces not adaptable for future use.

• True

• False

Lighting Outlets Required
Habitable Rooms: At least ___ wall switch controlled lighting outlet shall be installed in every habitable room, kitchen and bathroom

• 1

• 2

• 3

• 4

Spacing: Receptacles shall be installed such that no point measured horizontally along the floor line of any wall space is more than ____ mm from a receptacle outlet.

• 3600

• 600

• 1800

• 1200

Garage Branch Circuits: This circuit shall not be permitted to supply readily accessible outdoor receptacle outlets.

• True

• False

Branch Circuits Larger Than 50 Amperes: Branch circuits larger than 50 amperes shall be allowed for lighting outlet loads

• True

• False

At least one entrance not less than 600 mm wide and 2000 mm high shall be provided to give access to the working space about electric equipment. Where the entrance has a personnel door(s), the door(s) shall open in the direction of ingress and be equipped with panic bars, pressure plates, or other devices that are normally latched but open under simple pressure.

• True

• False

Arcing Parts. Parts of electric equipment that in ordinary operation produce arcs, sparks, flames, or molten metal shall be enclosed or separated and isolated from all combustible material.

• True

• False

It is the part of the electrical plan that shows the following:
(1) Nature of electrical service, including number of phases, number of wires, voltage and frequency;

(2) Type of wiring;

(3) Special equipment to be installed, indicating ratings and classification of service or duty cycle

(4) System or method of grounding;

(5) Type and rating of main disconnecting means, overcurrent protection (OCP) and branch circuit wiring

( 6) Clearances of service drop, burial depth for service lateral, mounting height and clearance for service equipment, mounting height and clearance for kWh meter.

• Plan for Power

• Schedule of Loads.

• One Line Diagram

• General Notes and/or Specifications

Method of Operation: Circuit breakers shall be trip free and capable of being closed and opened by manual operation.

• True

• False