HAND TOOLS

From which type of Steel are Files produced?

• They are made from high carbon steel and they are heat treated so that they are tougher than the steel or other materials that they are to be used on

• They are made from Low carbon steel and they are heat treated so that they are tougher than the steel or other materials that they are to be used on

• They are made from Medium carbon steel and they are heat treated so that they are tougher than the steel or other materials that they are to be used on

Which shapes are best formed by the use of a Half Round File?

• Used for filing ‘tight’ corners and angles of less than 90 degrees.

• Used for filing irregular shaped work or large radii

• Used for filing corners, angles of greater than 90°

Which shapes are best formed by the use of a Tri/Three square file?

• Used for filing ‘tight’ corners and angles of less than 90 degrees.

• Used for filing irregular shaped work or large radii

• Used for filing corners, angles of greater than 90°

Which shapes are best formed by the use of a Tri/Three square file?

• Used for filing ‘tight’ corners and angles of less than 90 degrees.

• Used for filing irregular shaped work or large radii

• Used for filing corners, angles of greater than 90°

When using a Hacksaw, on what metal should you use a high TPI blade?

• soft metals (because there is space for the chips).

• hard metals (to get more teeth doing the work)

• thick metals (because there is space for the chips).

When using a Hacksaw, on what metals should you use a Low TPI blade?

• soft metals (because there is space for the chips)

• hard metals (to get more teeth doing the work)

Which hand tool could you use to form an internal (female) screw thread in a pre-drilled hole?

• A thread die

• A set of hand taps

• An adjustable reamer

• A pipe screw threading machine

Which hand tool could you use to form an external (male) screw thread to a bar of known diameter?

• A thread die

• A set of hand taps

• An adjustable reamer

• A pipe screw threading machine

Which hand tool would you use for general marking out of arcs, circles, and radii?

• Internal Calipers

• Spring Dividers

• External Calipers

• Vernier Calipers

Which hand tool from the list could you use to measure a gap width?

• External micrometer

• Internal Radius Gauge

• Feeler gauges

• Angle plates