Test #4

What are the names of the three components that make up a wood I-joist?

• PSL web with 2x3 Flanges

• OSB Flanges with an LVL web

• 2x3 or LVL Flanges with an OSB web

• glulam flanges with a PSL web

Which engineered lumber product has a stamped marking of TOP, which indicates the edge that is required to be facing upwards once installed?

• parallel strand lumber

• glulam beams

• laminated strand lumber

• laminated veneer lumber

What type of engineered product is used to manufacture exterior siding strips (Canexel)?

• LDF

• MDF

• HDF

• particle board

what is the dimension of an engineered panel product used to manufacture cabinets?

• 47' x 95"

• 48 1/2" x 96 1/2"

• 49" x 97"

• 50" x 100"

What is the standard dimension for a sheet of Canadian made Softwood Plywood?

• 2 feet x 4 feet

• 2 feet x 8 feet

• 4 feet x 4 feet

• 4 feet x 8 feet

Which of the following species is least likely to be used as the veneer core for COFI plywood?

• spruce

• poplar

• fir

• pine

What is the moisture content that Plywood veneers are dried to, before they are laminated into a panel form?

• 5% or less

• 6% - 8%

• 10% - 12%

• 13% - 19%

What engineered wood product is commonly used to fabricate counter tops?

• Hardboard

• Particle board

• veneer core plywood

• low density fibreboard

What does the stamped marking of "EXT" represent on a sheet of CANPLY plywood?

• requires exterior paint or stain

• is made with waterproof glue

• may be stored outside

• the side that faces out is to the exterior

What does the term "Cross-lamination" for plywood represent?

• the recommended installation method for plywood

• the gluing method used in plywood manufacture

• the centre layer of a sheet of plywood

• gluing alternate layers at right angles to each other