Tinker Questions

What are the two combined components of Tinkercad Circuits?

• The coding interface and Arduino interface

• The coding interface and hardware interface

• The wiring interface and programming language

• The schematic design and coding panel

What should you do first to start working on your saved project in Tinkercad?

• Click the "Create new" button

• Open the Circuits area and select "Tinker this" on your project

• Go to the wiring section and set up the components

• Find your code in the code library and upload it

What happens when you click on the hardware area while coding in Tinkercad?

• The hardware gets disconnected

• The code gets reset to its initial state

• The coding interface may close

• The project automatically saves

Which of the following actions is controlled by the mouse wheel in Tinkercad?

What is the significance of the colors used in the programming blocks in Tinkercad?

• They indicate the level of difficulty for each block

• They represent different programming categories

• They indicate whether the blocks are connected correctly

• They are used to differentiate between inputs and outputs

What color represents the Control blocks in Tinkercad?

• Orange

• Green

• Pink

• Blue

Which type of block would you use to perform a mathematical calculation in Tinkercad?

• Control (orange)

• Variables (pink)

When creating the voltage calculation, what is the multiplier value used in the math equation?

• 1023

• 5

• 1.023

• 1125

In the Tinkercad Arduino program, what is the purpose of creating a variable called "Voltage"?

• To measure the current flowing through the circuit

• To store the calculated voltage from the solar panel

• To set the LED brightness

• To control the digital output pin

What does the "set pin X to HIGH" block do in the program?

• It sets the output of pin X to high voltage, turning on a component like an LED

• It turns off the component connected to pin X

• It saves the current code configuration

• It resets the output pin to its default state