G4 Pratice Test 1

The name and use of the hand tool shown below is:

• Hacksaw used for cutting gaskets

• File used for cutting metal

• Hacksaw used for cutting metal

• File used for cleaning battery terminals

The name and use of the tool shown below is:

• Tapered punches used to drive split pins out of holes

• Stud extractors used for removing broken studs

• Taps used to cut left hand threads in metal

• Allen keys used to remove grub screws

The name and use of the hand tool shown below is:

• File used for cutting and shaping metal

• Feeler gauge used for measuring gaps

• Engineers screwdriver used for tightening screws

• Tyre lever for removing tyres

The name and use of the tool shown below is:

• Micrometer used for measuring

• Dial gauge used for measuring

• Clamp used for holding things

• Vice used for making brake pipes

The name and use of the tool shown below is:

• Digital micrometer used for measuring

• G clamp used for holding things

• Vice used for compressing springs

• Digital vernier caliper used for measuring

A non-magnetic feeler gauge should be used to set the reluctor / pick-up gap on some electronic ignition distributor units.

• True

• False

A micrometer can be used to measure items as small as:

• 0.01mm

• 0.25mm

• 0.025mm

• 0.1mm

When finishing a task on a vehicle it is best to:

• Only clean up once a week as this wastes valuable time

• Leave the hand tools on the bench ready for the next job

• Put all hand tools away without cleaning as they will go rusty

• Check and clean all hand tools and place them in their tool chest

The mushroomed head of a cold chisel or punch should not be removed.

• True

• False

The tool shown below is:

• Multi-meter

• Voltmeter

• Ammeter

• Ohmmeter