Network Management

Which command is used to enable Cisco Discovery Protocol (CDP) on a specific interface?

• cdp advertise

• cdp start

• cdp enable

• cdp run

A network engineer needs to verify neighboring devices using CDP. Which command should they use to view a list of CDP neighbors?

• show neighbors

• show cdp detail

• show cdp neighbors

• show interface

In a mixed network environment with Cisco and non-Cisco devices, which protocol would allow a network administrator to gather information about neighboring devices from different vendors?

• CDP

• LLDP

• OSPF

• RIP

An administrator wants to check the detailed information about a neighbor device using LLDP. Which command should they use?

• show lldp

• show lldp interface

• show lldp detail

• show lldp neighbors detail

Which of the following is a stratum 0 device in the context of NTP?

• GPS clock

• NTP client

• Atomic clock

• Network server

A network administrator needs to synchronize time across devices on the network. Which command configures an NTP server on a device?

• ntp set ip-address

• ntp time ip-address

• ntp synchronize ip-address

• ntp server ip-address

If an NTP device is synchronized with a stratum 1 server, what stratum level is assigned to this device?

• Stratum 0

• Stratum 1

• Stratum 2

• Stratum 3

A network engineer wants to check which interfaces on a device are CDP-enabled. Which command will provide this information?

• show cdp

• show cdp neighbors

• show cdp interfaces

• show cdp enabled

What component in SNMP contains the actual network device information to be monitored or modified?

• OID

• MIB

• Community string

• SNMP trap

A network administrator configures SNMP on a device and sets a community string. Which of the following is the correct default security level for SNMPv2c with a community string?

• Encrypted and authenticated

• Authenticated only

• Community-based security

• No security