S3 PWW - (Message Board) Marking Out

What is the primary use of a pencil in marking-out?

• To engrave the workpiece

• To mark lines and centers for cutting or joining

• To measure materials for cutting

• To scribe a double line parallel to an edge

How should a steel rule be used for accurate measurements?

• Used to engrave the workpiece

• Held at an angle

• Flat against the side and bottom edges

• Used with a sharp pencil

What is the function of a try square?

• To scribe lines parallel to edges

• To draw perpendicular lines on materials

• To set an angle for cutting

• To cut a line into wood parallel to an edge

Which tool is used to scribe a line parallel to an edge?

• Cutting gauge

• Mortise gauge

• Marking gauge

• Sliding bevel

What is the purpose of a cutting gauge?

• To mark the bottom of a woodwork joint

• To set an angle for cutting

• To measure materials for cutting

• To draw perpendicular lines

How is a mortise gauge different from a marking gauge?

• It is used to set an angle for cutting

• It is used to scribe a double line parallel to an edge

• It is used to measure materials for cutting

• It is used to draw perpendicular lines

What is the function of a sliding bevel?

• To set an angle for cutting waste material

• To engrave the workpiece

• To scribe lines parallel to edges

• To measure materials for cutting

What should be ensured when using a marking gauge?

• The spur should dig into the material

• The stock should be flat against the side of the workpiece

• The tool should be held at an angle

• The line should be engraved deeply