Safety Review

What is the maximum amount you should remove in each pass to ensure the best quality finish and least strain on the machine?

• 1/8 inch

• 1/16 inch

• 1/4 inch

• 1/32 inch

What is the shortest piece that should go through the planer?

• 8 inches

• 12 inches

• 10 inches

• 6 inches

Where should you stand to push the stop button if needed?

• Left side of the table

• Right side of the table

• Behind the machine

• In front of the machine

What should you do if a board becomes stuck in the machine?

• Pull the board out

• Stop the machine or stick another board to push the other board

• Push harder on the board

• Leave it and try later

How should you run boards to put even wear on the cutterhead?

• Run boards in the same place

• Run boards in different places

• Run boards quickly

• Run boards slowly

What is unsafe when running multiple boards through the planer?

• If they are the same thickness

• If they are different thicknesses

• If they are too long

• If they are too short

How do you adjust the amount of material removed by the planer?

• Adjust the outfeed bed

• Adjust the infeed bed

• Adjust the infeed roller

• Adjust the outfeed roller

What is the primary purpose of the planer?

• To make boards thicker

• To make boards thinner

• To polish boards

• To cut boards

Where are the cutterhead blades of a planer located?

• Below the board

• Above the board

• Beside the board

• In front of the board

What happens if you input a dimension without a decimal point?

• The planer will accept it

• The planer will show 'ERROR'

• The planer will ignore it

• The planer will round it