AEU Knowledge Check

What is the length of the CCM Address Extension Unit - AEU (ATU-PVT-SBM1)?

• 690 mm

• 310 mm

• 500 mm

• 1000 mm

• 800 mm

How many CCM units does the AEU (ATU-PVT-SBM1) count for power supply calculation?

• 5 units

• 3 units

• 4 units

• 1 unit

• 2 units

Which units can be installed downstream of AEU (ATU-PVT-SBM1)?

Choose all that apply.

• ATU-PVT-TT

• ATU-PVT-LC (03, 05, 07, 10)

• ATU-PVT-SBM1

• ATU-PVT-LBF05

• ATU-PVT-AOB

What are the benefits of using the AEU (ATU-PVT-SBM1) in a CCM Solution?

Choose all that apply.

• Fast rerun before storing or sending out the rack

• Optimized distribution of rack among mirrored systems

• Creation of a rack-position link sent to middleware

• Increase the number of possible primary targets (analyzers) reached by the rack

• More efficient add-on testing as recursive flowMore efficient add-on testing as recursive flow

What happens when ALL 5 sample tubes AND rack barcodes cannot be identified?

• Independent from the AEU settings, it will always trigger a STOP alarm

• It will always send the rack to the configured default destination 

• Rack will be sent to the upstream unit connected to AEU

• Rack will be forwarded to the same path as received from upstream CCM unit

• Depending on the  AEU settings, it can either display a STOP alarm or forward the rack to the configured default destination

What is the purpose of the barcode labels brackets located on the pull-in conveyor of AEU (ATU-PVT-SBM1)?

• To inform the rack ID

• To detect / inform, if the specific rack position is empty or occupied by sample tube

• To inform the sample ID

• To adjust the rack ID barcode reader

• To adjust the sample ID barcode reader

Which functionalities apply to the AEU (ATU-PVT-SBM1)?
Choose all that apply.

• Rack barcode identification

• Communication to middleware

• Assignment of new path to racks

• Communication to analyzer

• Availability of path (rack-jam/RTR signal) is sent to middleware

Which procedure must be performed after replacing the rack ID barcode reader with a new one?
Choose all that apply.

• Self-driven BCR reading stop position adjustment

• Configuration of the readable barcode types

• Rack ID reading position adjustment

• Rack ID BCR initial setting

• Self-driven BCR reading start position adjustment

What is the jumper setting for JP610 on the drive board UN201 to "bridge" the sensor of the protective cover during the adjustment procedure?

• JP610 to 2-3 short

• JP610 to 1-2 short

• JP610 3-4 short

What is the expected time for AEU to receive the "Respond Path Message"  from middleware?

• 10 ms

• 7 s

• 30 ms

• 10 s

• 12 s