AE03 P2

Which way do electrons flow in an electrical circuit?

• South to north

• North to south

• Positive to Negative

• Negative to positive

Identify the component shown.

• Surge protection diode

• Regulator

• Rectifier

• Stator

Identify the component shown.

• Rotor

• Armature

• Field coil

• Commutator

When fitting new starter bushes, what must be done prior to fitment?

• They must be reamed to size

• They must be ground to size

• They must be impregnated with oil

• They must be greased

Identify the component shown below.

• Rectifier

• Resistor

• Field winding

• Solenoid

A starter motor is presented to you for testing which is clicking but not turning. You suspect the solenoid is the fault but what would be the most logical test to start with?

• Resistance test between the solenoid trigger connector and the output connector

• An insulation test on the solenoid cap, looking for a voltage leak

• A volt drop test across the input/output connectors

• Resistance test between the solenoid trigger connector and earth

Identify the component shown.

• Regulator

• Stator

• Rectifier

• Rotor

When you carry out a stator test you should carry out two tests. These would be:

• voltage output test and an insulation test

• resistance test and a current draw test

• current draw test and voltage output test

• resistance test and an insulation test

In a DC generator where is the rectification carried out?

• The field windings

• The dynamo regulator

• The rectifier

• The commutator

A typical conductor would be?

• Wood

• Copper

• Glass

• Rubber