High-Force Cable Pulling Quiz

What is one of the objectives of Section Two?

• Set up for high-force cable pulling.

• Install lighting fixtures.

• Design electrical circuits.

• Test voltage levels.

Which of the following is a step in setting up for high-force cable pulling?

• Set up the feeding end.

• Install circuit breakers.

• Measure electrical resistance.

• Test insulation.

What should be done after setting up the feeding end in high-force cable pulling?

• Support conductors.

• Install transformers.

• Test for continuity.

• Measure current flow.

What is the final step in the high-force cable pulling process mentioned in the objectives?

• Pull cable in cable trays.

• Install junction boxes.

• Test circuit functionality.

• Measure voltage drop.

What is required to ensure a safe and smooth operation in high-force cable pulling?

• Quick execution

• Careful planning

• Minimal equipment

• High speed

What equipment is necessary between both ends of a high-force cable pull?

• Lighting equipment

• Cooling equipment

• Communications equipment

• Heating equipment

What is the proper way to unroll a cable according to its natural curvature?

• Unroll the cable in a straight line

• Unroll the cable along its natural curvature

• Unroll the cable in a zigzag pattern

• Unroll the cable in a circular motion

What type of auxiliary equipment can be used to facilitate cable installation?

• Reels, guides, and sheaves

• Hammers, nails, and screws

• Pulleys, levers, and wedges

• Drills, saws, and sanders

What is the purpose of single sheaves in cable installations?

• To cut cables

• To guide cable through the conduit

• To connect cables

• To measure cable length

Why must the sheave radius be matched to the bend?

• To ensure a smooth pull

• To increase cable speed

• To reduce cable length

• To change cable color