Driving Test

If there is a deep puddle ahead I should

• Try to avoid it
• Slow down and drive through it

• Speed up and go through it

• None of the above

Answer explanation

Never drive through a puddle where you cannot see the bottom: as it could be deep enough to damage your car or cause hydroplaning.

What should you do after going through a deep puddle ?

• Continue driving

• Speed up

• Brake lightly a few times

Answer explanation

Your brakes may not function properly after driving through a deep puddle as your brakes will become wet. Braking lightly a couple of timesevaporates the water and makes your brakes function properly again. Consider this a good safety precaution after driving through deep water or a deep puddle.

What does this sign mean

• Do not drive past the sign

• You’re not allowed to overtake or pass another vehicle in this area .

• You cannot enter this roadway

Answer explanation

A "Do Not Pass" sign means that drivers are not allowed to overtake or pass another vehicle in that area, typically because the road conditions ahead are not safe for passing, such as on a curve or hill with limited visibility; it indicates the start of a "no passing zone.This sign is usually placed where passing could be dangerous due to poor visibility, sharp turns, or other road hazards

At an intersection with stop signs on all corners, yield the right-of-way to any driver:

• On your left

• Who arrived before you

• Across from your vehicle

• Who is driving fast through the stop sign

Answer explanation

After coming to a full stop, vehicles should proceed through a four-way stop in the order in which they arrive to the intersection. If multiple vehicles arrive at the same time, the vehicle on the left must yield the right-of-way to the vehicle on the right. If someone is speeding through the stop sign , let them go !

Sudden wind gusts on the highway can

• Cause you to swerve or lean

• Cause problems for any car

• Cause visibility problems

Answer explanation

While it can create special problems for large vehicles, strong wind can cause problems for all drivers. Wind can lower visibility by blowing dirt and dust into the roadway, but it can sometimes also physically move a vehicle.

If you want to pass a pedestrian who is walking along the roadway and an oncoming vehicle is approaching, you should:

• Speed up in order to pass the pedestrian before the car passes

• Slow down & let the car pass before passing the pedestrian

• Keep driving , the upcoming vehicle must pass for you

• Honk your horn to get the pedestrian to move over

What is the purpose of rumble strips ?

• To slow down cars

• Bring attention to tire problems

• Test vehicles shock absorptions

• Through vibration and sound, they alert inattentive drivers to the fact that their vehicles have left the travel lane.

Answer explanation

Rumble strips create noise and vibrations to warn drowsy or inattentive drivers that they are straying off of the road or are approaching a stop sign or signal.

It is very foggy. You should slow down and:

• turn on emergency flashers & drive cautiously

• Turn on your brights

• Turn lights on lowest beam setting

Answer explanation

Use your low beams when driving in fog, snow, rain, or mist. Light from high beams will reflect off of precipitation, causing a glare and making it even more difficult to see. Some vehicles are equipped with fog lights that should be used in addition to low beam headlights.

When driving in heavy rain, you should:

• Speed up to get through the rain quickly

• Turn off your headlights

• Turn on your high beams

• Use your windshield wipers and drive slowly

What should you do if your car starts to skid on ice?

• Turn the steering wheel in the opposite direction of the skid

• Brake hard immediately

• Turn the steering wheel in the direction of the skid

• Accelerate to regain control