Quiz-13

Which value in a routing table represents trustworthiness and is used by the router to determine which route to install into the routing table when there are multiple routes toward the same destination?

• • administrative distance

• • metric

• • outgoing interface

• • routing protocol

What is a characteristic of a floating static route?

• • When it is configured, it creates a gateway of last resort.​

• • It is used to provide load balancing between static routes.

• • It is simply a static route with 0.0.0.0/0 as the destination IPv4 address.

• • It is configured with a higher administrative distance than the original dynamic routing protocol has.

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)

• • the interface ID of the next-hop neighbor

• • the interface ID exit interface

• • the IP address of the exit interface

• • the IP address of the next-hop neighbor

• • the administrative distance for the destination network

What route would have the lowest administrative distance?

• • a route received through the OSPF routing protocol

• • a directly connected network

• • a static route

• • a route received through the EIGRP routing protocol

What characteristic completes the following statement?
When an IPv6 static route is configured, it is first necessary to configure ……

• • the next-hop address of two different adjacent routers.

• • the “ipv6 unicast-routing” command.

• • an IPv6 link-local address on the adjacent router.

• • an administrative distance of 2.

50. What are two advantages of static routing over dynamic routing? (Choose two.)

• 
  

• • Static routing is more secure because it does not advertise over the network.

• • Static routing scales well with expanding networks.

• • Static routing requires very little knowledge of the network for correct implementation.

• • Static routing uses fewer router resources than dynamic routing.

A network administrator configures the interface fa0/0 on the router R1 with the command ip address 172.16.1.254 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem?

• • The subnet mask is incorrect for the IPv4 address.

• • The configuration needs to be saved first.

• • The interface fa0/0 has not been activated.

• • No packets with a destination network of 172.16.1.0 have been sent to R1.

What characteristic completes the following statement?
When an IPv6 static route is configured, the installation of the route can be verified with ……

• • a destination host route with a /128 prefix.

• • the interface type and interface number.

• • the “show ipv6 route static” command.

• • an administrative distance of 2.