Dremel Safety Quiz

Do not reach in the area of the__________bit.

• drilling

• spinning

• cutting

• grinding

Use __________ or another practical way to secure and support the work piece to a stable platform.

• Clamps/Vice

• Nails

• Tape

• Glue

After changing the bits or making any adjustments, make sure the collet nut and the EZ TWIST integrated wrench/ nose cap are both securely ______________.

• loosened

• tightened

• adjusted

• removed

What part is letter E?

• Shaft Lock Button

• On Off Switch

• Cord

• Hanger

________ handle both the tool and individual grinding wheels to avoid chipping or cracking. Install a new wheel if tool is dropped while grinding. Do not use a wheel that may be damaged

• carefully

• hastily

• recklessly

• carelessly

If cutting into existing walls or other blind areas where electrical wiring may exist is unavoidable, _______________all fuses or circuit breakers feeding this worksite.

• disconnect

• connect

• ignore

• inspect

What part is letter I? Vent Openings, Brush Cover, Cord, Hanger

• Vent Openings

• Brush Cover

• Cord

• Hanger

Regularly clean the tool’s air vents by _________ air.

• suctioning

• compressed

• blowing

• filtering

Always hold the hand piece _______ in your hands during the start-up.

• loosely

• firmly

• carelessly

• gently

Allow brushes to run at__________speed for at least one minute before using wheel. During this time no one is to stand in front or in line with the brush.

• operating

• maximum

• minimum

• average