Latihan EXAM CCNA 315-350

Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?

• 
• 
• 
• 

Refer to the exhibit. R1 has just received a packet from host A that is destined to host B. Which route in the routing table is used by R1 to reach host B?

• 
• 
• 
• 

What is the advantage of separating the control plane from the data plane within an SDN network?

• A. reduces cost

• B. limits data queries to the control plane

• C. decreases overall network complexity

• D. offloads the creation of virtual machines to the data plane

A router has two static routes to the same destination network under the same OSPF process. How does the router forward packets to the destination if the next hop devices are different?

• A. The router load-balances traffic over all routes to the destination.

• B. The router chooses the next hop with the lowest IP address.

• C. The router chooses the next hop with the lowest MAC address.

• D. The router chooses the route with the oldest age

Refer to the exhibit. The image server and client A are running an application that transfers an extremely high volume of data between the two. An engineer is configuring a dedicated circuit between routers R1 and R2. Which set of commands must the engineer apply to the two routers so that only traffic between the image server and client A is forced to use the new circuit?

• 
• 
• 
• 

Refer to the exhibit. The My_WLAN wireless LAN was configured with WPA2 Layer 2 PSK security .Which additional configuration must the administrator perform to allow users to connect to this WLAN on a different subnet called Data?

• A. Enable Status and enable Broadcast SSID.

• B. Enable Status and set the NAS-ID to data.

• C. Enable Broadcast SSID and seiect data from the lnterfacettnterface Group drop-down list.

• D. Enable Status and select data from the Interface/Interface Group drop-down list.

Which lPsec mode encapsulates the entire IP packet?

• A. SSL VPN

• B. transport

• C. Q-in-Q

• D. tunnel

Which set of commands are needed to allow only SSH access and hide passwords in the running configuration?

• 
• 
• 
• 

Refer to the exhibit. Clients on the WLAN are required to use 802.11r. What action must be taken to meet the requirement?

• A. Set the Fast Transition option to Enable and enable FT 802.1X under Authentication Key Management.

• B. Set the Fast Transition option and the WPA gtk-randomize State to disable.

• C. Enable CCKM under Authentication Key Management.

• D. Under Protected Management Frames, set the PMF option to Required.

What is the benefit of using FHRP?

• A. reduced management overhead on network routers

• B. higher degree of availability

• C. balancing traffic across multiple gateways in proportion to their loads

• D. reduced ARP traffic on the networK