SRWE Module 1.1.1 - 1.1.7

Match the five steps for a Cisco Switch when booting up....

• 5

• First, the switch loads a power-on self-test (POST) program stored in ROM. POST checks the CPU subsystem.

• 2

• Finally, the boot loader locates and loads a default IOS operating system software image into memory and gives control of the switch over to the IOS.

• 1

• Next, the switch loads the boot loader software. The boot loader is a small program stored in ROM that is run immediately after POST successfully completes.

• 3

• The boot loader performs low-level CPU initialization. It initializes the CPU registers, which control where physical memory is mapped, the quantity of memory, and its speed.

• 4

• The boot loader initializes the flash file system on the system board.

boot system flash:/c2960-lanbasek9-mz.150-2.SE/c2960-lanbasek9-mz.150-2.SE.bin

• boot system

• The path to the file system

• c2960-lanbasek9-mz.150-2.SE/

• The storage device

• flash:

• The main Command

• c2960-lanbasek9-mz.150-2.SE.bin

• The IOS file name

Match the following functions to the corresponding LED light

• Redundant Power System(RPS) LED

• If the LED is off, the port is operating at 10 Mbps. If the LED is green, the port is operating at 100 Mbps. If the LED is blinking green, the port is operating at 1000 Mbps.

• System LED

• Shows whether the system is receiving power and is functioning properly

• Port Speed LED

• Indicates that the port status mode is selected when the LED is green. This is the default mode.

• Port Duplex LED

• Indicates that the port duplex mode is selected when the LED is green. When selected, port LEDs that are off are in half-duplex mode. If the port LED is green, the port is in full-duplex mode.

• Port Status LED

• Shows the RPS status. If the LED is off, the RPS is off, or it is not properly connected. If the LED is green, the RPS is connected and ready to provide backup power.

Order the five steps when recovering from a system crash

• 2

• The boot loader switch: prompt appears in the terminal emulation software on the PC.

• 1

• Reconnect the power cord to the switch and, within 15 seconds, press and hold down the Mode button while the System LED is still flashing green.

• 3

• Continue pressing the Mode button until the System LED turns briefly amber and then solid green; then release the Mode button.

• 5

• Connect a PC by console cable to the switch console port. Configure terminal emulation software to connect to the switch.

• 4

• Unplug the switch power cord.

Order the following commands when configuring a SVI

• 2

• conf t

• 4

• interface vlan 99

• 5

• end

• 3

• ip address {ip address} {subnet mask}

• 1

• no shutdown

Which component of the boot sequence analyzes hardware devices before loading
the operating system?

• system diagnostics

• setup utility

• power-on-self-test

• bootstrap loader