What is the purpose of the OSI physical layer?

• controlling access to media
• transmitting bits across the local media
• performing error detection on received frames
• exchanging frames between nodes over physical network media

Why are two strands of fiber used for a single fiber optic connection?

• The two strands allow the data to travel for longer distances without degrading.
• They prevent crosstalk from causing interference on the connection.
• They increase the speed at which the data can travel.
• They allow for full-duplex connectivity.

Which characteristic describes crosstalk?

• the distortion of the network signal from fluorescent lighting
• the distortion of the transmitted messages from signals carried in adjacent wires
• the weakening of the network signal over long cable lengths
• the loss of wireless signal over excessive distance from the access point

Which procedure is used to reduce the effect of crosstalk in copper cables?

• requiring proper grounding connections
• twisting opposing circuit wire pairs together
• wrapping the bundle of wires with metallic shielding
• designing a cable infrastructure to avoid crosstalk interference
• avoiding sharp bends during installation

A network administrator is measuring the transfer of bits across the company backbone for a mission critical financial application. The administrator notices that the network throughput appears lower than the bandwidth expected. Which three factors could influence the differences in throughput? (Choose three.)

• the amount of traffic that is currently crossing the network
• the sophistication of the encapsulation method applied to the data
• the type of traffic that is crossing the network
• the latency that is created by the number of network devices that the data is crossing
• the bandwidth of the WAN connection to the Internet

What are two characteristics of fiber-optic cable? (Choose two.)

• It is not affected by EMI or RFI.
• Each pair of cables is wrapped in metallic foil.
• It combines the technique of cancellation, shielding, and twisting to protect data.
• It typically contains 4 pairs of fiber-optic wires.
• It is more expensive than UTP cabling is.

What is a primary role of the Physical layer in transmitting data on the network?

• create the signals that represent the bits in each frame on to the media
• provide physical addressing to the devices
• determine the path packets take through the network
• control data access to the media

With the use of unshielded twisted-pair copper wire in a network, what causes crosstalk within the cable pairs?

• the magnetic field around the adjacent pairs of wire
• the use of braided wire to shield the adjacent wire pairs
• the reflection of the electrical wave back from the far end of the cable
• the collision caused by two nodes trying to use the media simultaneously

Refer to the graphic. What type of cabling is shown?

• STP
• UTP
• coax
• fiber

In addition to the cable length, what two factors could interfere with the communication carried over UTP cables? (Choose two.)

• crosstalk
• bandwidth
• size of the network
• signal modulation technique
• electromagnetic interference