VFR Sectional KC

[Area 7] The airspace overlying McKinney (TKI) is controlled from the surface to:

• 2,900 feet MSL

• 2,500 feet MSL

• 700 feet AGL

(Refer to Figure 20, area 5.) The CAUTION box denotes what hazard to aircraft?

• Unmarked balloon on cable to 3,008 feet MSL.

• Unmarked balloon on cable to 3,008 feet AGL.

• Unmarked blimp hangars at 300 feet MSL.

(Refer to Figure 75, area 6.) During preflight planning, you plan to operate in R-2305. Where would you find additional information regarding this airspace?

• In the Aeronautical Information Manual.

• In the Charts Supplements U.S.

• In the Special Use Airspace area of the chart.

(Refer to Figure 25, area 3.) The floor of Class B airspace at Dallas Executive (RBD) is:

• at the surface.

• 3,000 feet MSL.

• 3,100 feet MSL.

(Refer to Figure 21, area 2.) Which airport is located at approximately 47°34'30"N latitude and 100°44'00"W longitude?

• Turtle Lake.

• Makeeff.

• Johnson.

(Refer to Figure 21, area 1.) After receiving authorization from ATC to operate a small UA near Minot International airport (MOT) while the control tower is operational, which radio communication frequency could be used to monitor manned aircraft and ATC communications?

• UNICOM 122.95

• ASOS 118.725

• CT-118.2

(Refer to Figure 20, area 2.) The flag symbol at Lake Drummond represents a

• compulsory reporting point for Norfolk Class C airspace.

• compulsory reporting point for Hampton Roads Airport.

• visual checkpoint used to identify position for initial callup to Norfolk Approach Control.

What action should a remote pilot take when operating in a Military Operations Area (MOA)?

• Obtain a clearance from the controlling agency prior to entering the MOA.

• Operate only on the airways that transverse the MOA.

• Exercise extreme caution when military activity is being conducted.

(Refer to Figure 25, area 4.) The floor of Class B airspace overlying Hicks Airport (T67) north-northwest of Fort Worth Meacham Field is:

• at the surface

• 3,200 feet MSL

• 4,000 feet MSL

(Refer to Figure 78.) You have been hired to use your small UAS to inspect the railroad tracks from Blencoe (SE of Sioux City) to Onawa. Will ATC authorization be required?

• Yes, Onawa is in Class D airspace that is designated for an airport.

• No, your entire flight is in Class G airspace.

• Yes, you must contact the Onawa control tower to operate within 5 miles of the airport.