VEX V5 Coding Blocks

What behavior will the VR Robot perform if the condition of the Left Bumper Sensor being pressed is TRUE?

• The VR Robot will continue to drive forward forever.

• The VR Robot will drive in reverse for 50 millimeters (mm) and then turn left for 90 degrees.

• The VR Robot will stop moving.

• The VR Robot will drive forward for 50 millimeters (mm) and then turn right for 90 degrees.

Which of the following would result in the robot driving in a square?

• 
• 
• 
• 

Why is this car not starting when the bumper is pressed?

• Need to remove the wait

• Need to remove the stop

• Need a spin motor block after the set velocity block

• Need to get rid of the forever loop

The motor doesn't start when the bumper is pressed. What's wrong?

• Didn't put a stop motor

• Didn't use a forever loop

• Didn't tell the motor to spin

• Didn't put in a wait before the stop

Which block must be at the beginning of every program in VEXcode?

• 
• 
• 
• 

Which of the following describes why a Repeat block would be used in a project?

• To repeat certain blocks forever.

• To save space and time for blocks that repeat more than once in a project.

• To only run a stack of blocks one time.

• To run an attached stack of blocks when the project is started.

What do the grey blocks do in the V5 Coding System?

• They tell the robot what to do.

• They are comment blocks which make the code easier to read and understand what those blocks do.

• They detect errors in your code.

• The are event blocks, which cause the next set of blocks to execute when a specific event happens.

What is the primary function of a [Forever] block in a coding project?

• To execute a set of commands once.

• To repeat a set of commands indefinitely until the project is stopped.

• To execute commands only when a specific condition is met.

• To pause the execution of commands for a specified time.

Why would a [If then] block be used in a project?

• To execute a set of commands only if a certain condition is true.

• To repeat a set of commands a specific number of times.

• To ask the user a question.

• To execute commands in a random order.

What happens when a [Stop Project] block is used in a project?

• All motors stop spinning, but then start to run again.

• The project pauses for a specified amount of time.

• All actions and the project are stopped immediately.

• The project saves and continues running.