Which of the following engines is featured in the disassembly procedures presentation?

• Kohler® Command Pro CH 270

• Kohler® Command Pro CH 260

• Kohler® Command Pro CH 395

• Kohler® Command Pro CH 440

In the presentation, what is used to keep the assembly sequence of the levers and linkage together?

• A piece of tape

• A plastic bag

• A nylon or wire tie

• A rubber band

How many valves are in the engine featured in this presentation?

• One

• Six

• Four

• Two

Before disassembly, the fuel lever needs to be moved in what direction?

• All the way to the left

• All the way to the right

• To the neutral position

• To the stop position

Which of the following steps needs to occur before the carburetor is removed from the engine?

• The fuel tank should be removed

• Fuel should be drained from the carburetor

• Electrical systems need to be disconnected

• The engine oil needs to be drained

Which of the following should be used to remove the breather hose from the valve cover?

• Pliers

• Wrench

• Fingers

• Screwdriver

Which of the following steps should be used to remove the valves from the cylinder head?

• A. Push down on the keeper

• B. Pull up on the keeper

• C. Use a valve puller

• D. Tap out with a hammer

How many push rods are in the engine featured in this presentation?

• Six

• Four

• Two

• Eight

In the presentation, Scott Mack labels one of the tappets with the letter “I.” What does this stand for?

• Ignition

• Intake

• Inverted

• Internal

In order to properly remove the flywheel from the crankshaft, what tool should be used?

• Pry bar

• Pliers

• Flywheel Puller

• Hammer