Small Gas Engine: Assembly Procedures

TDC stands for which of the following?

• Top dead compression

• Top dead center

• Temperature delay control

• Torque drive converter

During reassembly, which direction should the triangle marking on the piston be pointing?

• Up

• To the left

• To the right

• Down

Which of the following is used to torque the screws inside the cylinder head?

• Screwdriver

• Adjustable wrench

• Deep socket and torque wrench

• Offset socket and torque wrench

According to the presentation, which of the following is the first step in preparing the engine for reassembly?

• A. Clean and inspect all parts

• B. Lay out all parts

• C. Pre-lubricate parts requiring lubrication

• D. Inventory all parts

Which of the following is used to properly install the closure plate screws into the crankcase?

• Screw installation sequence

• Random sequence

• Torque sequence

• Clockwise sequence

In the presentation, Scott Mack performs which of the following procedures before installing the spark plug?

• Measures the ground electrode

• Cleans carbon fouling

• Measures the gap

• Rotates the piston to top dead center

In the presentation, which of the following is used to lubricate the internal parts?

• Synthetic grease

• Silicone spray

• Engine oil

• Lithium grease

In the presentation, which of the following is used to set the gap between the flywheel magnet and ignition module legs?

• Air gap gauge

• Flat feeler gauge

• Flywheel gauge

• Calipers

Which direction should the oil slinger portion of the connecting rod cap be pointing during reassembly?

• Up

• To the left

• To the right

• Down

According to the presentation, which of the following is the first step when installing the ignition module?

• Rotate the flywheel magnet away from the location where the ignition module will be installed

• Install ignition module spacer

• Connect the black wires

• Align the flywheel magnet and ignition module legs