Electrical Trades review

Which of these tools should be used to cut bolts?

• Bolt Cutters

• Screwdriver

• Hammer

• Pliers

Which tool(s) could be (properly) used to “mark” or make a dent in metal so that a hold can be drilled at exactly that point with a power drill and drill bit?

• Center Punch

• Flat File

• Hacksaw

• Ball Peen Hammer

The recommended type of wrench for safely loosening a tightly secured bolt is (a)  

• 6 Point Socket
• Adjustable Wrench
• Pipe Wrench
• Open-End Wrench

Which of these hand tools are diagonal cutting pliers?

• Diagonal cutting pliers

• Needle nose pliers

• Slip joint pliers

• Linesman pliers

When working outdoors, before using an extension cord to operate a power tool, the extension cord should be _______.

• Inspected for damage

• Plugged in immediately

• Painted for visibility

• Tied in a knot

Cord sets and portable electric tools must be visually inspected _______.

• Before each use

• Once a week

• At the end of the month

• Only when damaged

MSDS is an abbreviation for _______.

• Material Safety Data Sheet

• Medical Safety Data Sheet

• Mechanical Safety Data Sheet

• Material Security Data Sheet

Work can be performed using power tools in wet locations if _______.

• The tool uses a low-voltage isolation transformer

• The tool is painted with waterproof paint

• The tool is plugged into any available outlet

• The tool is used only during daylight hours

Which of the following is NOT considered an electrical hazard by OSHA?

• Electric shock

• Arc flash

• Power Tool Injury

• Burns

You should have adequate working space when moving conduit in order to avoid contact with _______.

• Live parts

• Grounded surfaces

• Other conduits

• All of the above