Propeller Shaft Removal and Installation Quiz

What should be done after removing the propeller shaft according to the removal instructions?

• Insert plug into rear oil seal

• Tighten bolts securing transmission

• Fill transmission with gear oil

• Remove shift lever

What is the caution mentioned regarding the removal of the propeller shaft?

• Do not damage the catalytic converter

• Be careful not to damage spline, sleeve yoke, and rear oil seal

• Ensure the transmission is filled with oil

• Tighten all bolts to the same torque

What is the warning given for the removal process?

• Support the engine with a jack

• Support Manual Transmission while removing it

• Do not place jack under the oil pan drain plug

• Fill transmission with recommended gear oil

What is the purpose of the diagram in the installation section?

• To illustrate the removal of the propeller shaft

• To show the correct placement of the oil pan

• To indicate the bolt tightening sequence and torque specifications

• To demonstrate the filling of transmission with gear oil

Which component is always replaced with disassembly according to the diagram?

• Dust cover

• Oil seal

• Bearing retainer

• Drain plug

Which component is responsible for holding the mainshaft in place?

• Main drive gear ball bearing

• Snap ring

• Mainshaft ball bearing

• Thrust washer

What is the purpose of the return spring in the shift control components?

• To provide tension to the gearshift lever

• To lock the shift fork in place

• To assist in the return of the gearshift lever to its neutral position

• To secure the control housing

What is the first step in the disassembly process of the FS5W71C?

• Remove rear extension by lightly tapping it.

• Remove control housing, check ball, return spring plug, select check plunger and return springs.

• Separate transmission case from adapter plate.

• Remove front cover, gasket, countershaft front bearing shim, and main drive bearing snap ring.

Which component is removed by lightly tapping in the disassembly process?

• Control housing

• Rear extension

• Transmission case

• Front cover

During the disassembly process, what is removed after the retaining pins?

• Check ball plugs

• Interlock balls

• Rear extension

• Adapter plate