Part 2.2

You are configuring a new VLAN on a switch. Which step should you perform after creating the VLAN in the VLAN database to ensure devices can communicate within the VLAN?

• Assign the VLAN to the appropriate switch ports

• Enable port security on all switch ports

• Configure a static route for the VLAN

• Set the switch to transparent mode

A network administrator needs to configure a switch port to carry both data and voice traffic. Which configuration should be applied to the port?

• Assign the port to the native VLAN only

• Configure the port as an access port and assign a voice VLAN

• Set the port as a trunk without specifying VLANs

• Enable spanning tree on the port

When configuring 802.1Q trunking between two switches, what must be consistent on both ends to ensure proper VLAN tagging?

• The native VLAN ID

• The switch hostname

• The management IP address

• The spanning tree priority

A switch port is configured as a trunk. What is the purpose of the native VLAN in this configuration?

• It is used for untagged traffic on the trunk link

• It is used for management traffic only

• It is used for voice traffic only

• It is used to aggregate multiple links

You are tasked with configuring link aggregation between two switches. Which protocol can you use to automatically negotiate the aggregation?

• LACP

• STP

• 802.1Q

• VTP

A network engineer wants to increase the bandwidth between two switches. Which configuration should be implemented?

• Configure link aggregation using multiple physical links

• Assign both switches to the same VLAN

• Enable jumbo frames on both switches

• Set both switches to use the same native VLAN

Which configuration allows a switch to route traffic between VLANs?

• Create a Switch Virtual Interface (SVI) for each VLAN

• Assign all ports to the same VLAN

• Enable port security on all VLANs

• Configure link aggregation on all ports

A network administrator needs to ensure that voice traffic is prioritized over data traffic on a switch port. What should be configured?

• Assign a voice VLAN to the port

• Set the port speed to 10 Mbps

• Enable spanning tree on the port

• Configure the port as a trunk

Which action should you take to allow a port to carry traffic for multiple VLANs?

• Configure the port as a trunk port

• Assign the port to the native VLAN only

• Enable port security on the port

• Set the port speed to auto

A switch is configured with jumbo frames. What is the primary benefit of enabling this feature?

• It allows larger packets to be transmitted, reducing CPU overhead

• It increases the number of VLANs supported

• It improves spanning tree convergence time

• It enables link aggregation