EDA Quiz

Which file extension is used to save a PCB design in EasyEDA?

• .pcb

• .brd

• .sch

• .gerber

Which of these is used to connect two points in the schematic?

• Trace

• Route

• Wire

• Net

To add a new component in EasyEDA, you use the (a)   tool.

What does "Auto Routing" in EasyEDA do?

• Automatically adjusts the component size

• Automatically places components on the PCB

• Automatically connects the traces

• Automatically runs the simulation

What does the "Simulation" feature in EasyEDA allow you to do?

• Test the mechanical design of the PCB

• Verify the electrical behavior of the circuit

• Create 3D models of the components

• Measure the power usage of the circuit

What does the "Footprint" in EasyEDA refer to?

• The shape and size of the PCB

• The electrical connections of a component

• The simulation behavior of a component

• The physical layout of the components on the PCB

What does "ERC" stand for in EasyEDA?

• Electrical Resistor Check

• Electrical Rule Check

• Electrical Routing Check

• Engineering Resistor Check

To add a power source to your schematic, you use the (a)   component.

Which of the following layers in a PCB is used to define the copper trace that carries signals between components?

• Signal layer

• Ground plane

• Edge layer

• Silkscreen layer

In EasyEDA, which of the following is the first step to start designing a PCB?

• Schematic capture

• Component placement

• Routing traces

• Layer stacking