SSC Topic C388

What is the most frequent cause of fatal or serious boom forklift accidents?

• Tip-overs

• Being crushed between the forklift and a surface

• Being struck by the forklift

• Running the machine off an edge

Which of the following is NOT a safe practice when operating a telescopic handler?

• Performing maintenance with the engine running

• Checking tire pressures at the start of each shift

• Using outriggers when elevating loads on uneven surfaces

• Locking the boom swing before moving the machine on public roadways

What should be done before starting the machine to ensure safety?

• Ensure all hydraulic controls are in the neutral position

• Check the load limit indicator

• Perform an inspection of the vehicle's brakes

• Use a signaler to direct movement

Which of the following is a requirement for using a telescoping handler to lift co-workers?

• Workers must be able to shut-off power to the machine

• The machine must be operated on a flat surface

• The boom must be fully extended

• The machine must be in motion

What should be regularly inspected to avoid unsafe conditions when operating a telescopic handler?

• Brakes, lights, and warning devices

• Damage, defects, and unsafe conditions

• Hydraulic controls and tire pressures

• Load limit indicators and outriggers

Why should a telescopic handler never be operated in areas without sufficient ventilation?

• A buildup of carbon monoxide could occur

• The machine could overheat

• Visibility could be restricted

• The machine could tip over

What is the purpose of using a signaler when operating a telescopic handler?

• To direct movement in areas where visibility is restricted

• To check tire pressures

• To perform maintenance

• To lock the boom swing

Which of the following is a recommended practice when elevating loads on an uneven surface?

• Use outriggers

• Lower all attachments

• Check tire pressures

• Lock the boom swing

What should be done at the beginning of each shift to ensure the forklift will be stable under load?

• Check tire pressures

• Perform maintenance

• Use a signaler

• Lock the boom swing

What should be done before leaving the machine unattended?

• Set the parking brake and lower all attachments

• Perform an inspection of the vehicle's brakes

• Check tire pressures

• Use a signaler to direct movement